Pelican™ Protector Case™

Sensitive equipment needs protection, and since 1976 the answer has been the Pelican™ Protector Case. These cases are designed rugged, and travel the harshest environments on earth. Against the extreme cold of the arctic or the heat of battle, Pelican cases have survived.

Made in the USA, these tough cases are designed with an automatic purge valve, that equalizes air pressure, a watertight silicone O-ring lid, over-molded rubber handles and stainless steel hardware.

• Interior (L×W×D) - 13.56 x 5.76 x 11.70 in, (34.4 x 14.6 x 29.7 cm)
• Exterior (L×W×D) - 16.40 x 8.71 x 13.15 in, (41.7 x 22.1 x 33.4 cm)
• Lid Depth - 2.00" (5.1 cm)
• Bottom Depth - 9.70" (24.6 cm)
• Total Depth - 11.7" (29.7 cm)
• Int Volume - 0.53 ft³ (0.015 m³)
• Padlock Hole Diameter - 5/16" (8 mm)
• Weight With Foam - 6.50 lbs (2.9 kg)
• Weight Empty - 5.60 lbs (2.5 kg)
• Buoyancy - 59.00 lbs (26.8 kg)

Body Material - Polypropylene
Latch Material - ABS
O-Ring Material - Polymer
Pins Material - Stainless Steel
Foam Material - 1.3 lb Polyurethane
Purge Body Material - ABS
Purge Vent Material - 3 Micron Hydrophobic Non-Woven
Foam Layer 1 (Lid)2.06" (5.2 cm) - Convolute
Foam Layer 2 (Base)2.87" (7.3 cm) - Pick N Pluck (.50" x .50" squares)
Foam Layer 3 (Base)2.87" (7.3 cm) - Pick N Pluck (.50" x .50" squares)
Foam Layer 4 (Base)2.87" (7.3 cm) - Pick N Pluck (.50" x .50" squares)
Foam Layer 5 (Base)1.00" (2.5 cm) - Solid
Minimum Temperature - -40° F (-40 ° C)
Maximum Temperature - 210° F (99 ° C)
Certifications - IP67   /  STANAG 4280   /  Def Stan 81-41